Canon imageRUNNER ADVANCE 4551i Service Manual page 625

COPIER > DISPLAY > ACC-STS
SEND 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
HDD 1
Detail
Use Case
Adj/Set/Operate Method
IA-RAM 1
Detail
Use Case
Adj/Set/Operate Method
Unit
Amount of Change per
Unit
■ ANALOG
COPIER > DISPLAY > ANALOG
TEMP 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Appropriate Target Value
Related Service Mode
Amount of Change per
Unit
HUM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Appropriate Target Value
Related Service Mode
Amount of Change per
Unit
Dspl SEND support PCB installation state
To display the installation state of the PCB that supports SEND function.
If the PCB is installed, SEND function can be used.
When checking the connection between the machine and the PCB that supports SEND function
N/A (Display only)
0 to 1
0: Not installed, 1: Installed
Display of HDD model name
To display the model name of HDD.
When checking the model name of HDD used on the machine
N/A (Display only)
Dspl of MNCON PCB 1 DDR2-SDRAM capacity
To display the memory (DDR2-SDRAM) capacity of the Main Controller PCB 1.
When checking the memory capacity of the Main Controller PCB
N/A (Display only)
MB
1
Display of inside temperature
To display the temperature inside the machine detected by Environment Sensor.
When checking the temperature inside the machine
N/A (Display only)
0 to 60
deg C
20 - 27
COPIER> DISPLAY> ANALOG> HUM, ABS-HUM
1
Display of inside humidity
To display the humidity inside the machine detected by Environment Sensor.
When checking the humidity inside the machine
N/A (Display only)
0 to 100
%
30 - 70
COPIER> DISPLAY> ANALOG> TEMP, ABS-HUM
1
612
8. Service Mode