Canon imageRUNNER ADVANCE 4551i Service Manual page 866

SORTER > ADJUST
PNCH-X 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Additional Functions
Mode
Amount of Change per
Unit
BFF-SFT2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Punch hole pstn in feed way: Fin-J1/Y1
To adjust the punch hole position on puncher unit in feed direction.
As the value is incremented by 1, the punch hole moves by 0.1mm.
+: Toward delivery direction
-: Toward inlet direction
When the punch hole is displaced in feed direction
Enter the setting value, and then press OK key.
Fin-Y1
When selecting the precision priority by operation panel menu, this adjustment cannot be
executed.
-20 to 20
mm
0
SORTER> OPTION> PUCH-SW
Adjustment/Maintenance> Adjust Action> Switch Finisher Puncher Mode
0.1
Ppr displace amount on buffer: Fin-Y1
To adjust the paper displacement amount on Finisher Buffer Assembly.
As the value is incremented by 1, the paper position moves by 0.1mm.
+: The 2nd sheet of buffered paper shifts toward the inlet side
-: The 2nd sheet of buffered paper shifts toward the delivery side
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB,
enter the value of service label.
When the paper displacement occurs on the 2nd to 3rd sheets of buffered paper.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-60 to 60
mm
0
0.1
853
8. Service Mode