Canon imageRUNNER ADVANCE 4551i Service Manual page 445

5FA-8002-02
Detection Description
Remedy
602-0001-00
Detection Description
Remedy
Error in the Saddle Gripper Motor (Finisher-Y1)
The Saddle Gripper HP Sensor does not detect the saddle gripper when the Saddle Gripper Motor
has been driven for 1 second.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Saddle Gripper HP Sensor (PS209) to the Saddle Stitcher Controller PCB
- Harnesses from the Saddle Gripper Motor (M205) to the Saddle Stitcher Controller PCB
- Saddle Gripper HP Sensor (PS209)
- Saddle Gripper Motor (M205)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the malfunction in the swing guide unit.
2. Check whether there is not the malfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
HDD error
HDD failed to be Ready, or HDD was not formatted.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
[Related parts] R1.00
- Harnesses between the Main Controller PCB and the HDD
- HDD
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check the related harness/cable and connector.
2. Select COPIER> FUNCTION> SYSTEM> CHK-TYPE> "0", and execute "HD-CLEAR". Then,
turn OFF and then ON the main power.
[Reference] All the partitions that can be deleted are deleted.
3. Enter safe mode using (2+8) startup. Then format the HDD and reinstall the system software
using SST or a USB flash drive.
4. Check/replace the related parts.
432
7. Error/Jam/Alarm