Canon imageRUNNER ADVANCE 4551i Service Manual page 755

COPIER > OPTION > NETWORK
AFS-JOB
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
AFC-EVNT
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
ILOGMODE
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ILOGKEEP
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
1 Set of FAX server job reception port
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the reception port of the fax server to which a fax client sends jobs.
When changing the job reception port of the fax server
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 65535
20317
COPIER> OPTION> NETWORK> AFC-EVNT
1 Set of FAX client event reception port
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the event notification reception port of a fax client.
When changing the event notification reception port of a fax client
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 65535
29400
COPIER> OPTION> NETWORK> AFS-JOB
1 Setting of filter log target packet
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the target packet to be recorded in the filter log.
Usually, only the unicast packets to the machine are recorded in the filter log by PFW (personal
firewall).
When 1 is set, address filter is enabled for all protocols so all packets are recorded in the filter log.
However, logs of multicast/broadcast packets sent from a harmless device or an address that are
subject to rejection and have no direct relation to the machine are also recorded, and consequently
the number of logs is increased.
Upon user's request (to collect all filter logs)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When 1 is set, the number of logs is increased because logs of packets which have no direct
relation to the machine are recorded.
0 to 1
0: Unicast packets to the machine only, 1: All packets
0
1 Set of IP address block log hold time
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the retention time from the log time of IP block.
When access is made again from a same IP address which was blocked before, if it is within the
retention time of the previous log, its log is not recorded.
If access is frequently made from a same IP address, the log record of the UI might be filled with
its logs. If the user considers that a single log for a same IP address is enough, set the longer
retention time.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 48
0: 1 minute (special mode)
1 to 48: 1 hour to 48 hours
1
742
8. Service Mode