Canon imageRUNNER ADVANCE 4551i Service Manual page 869

SORTER > ADJUST
SW-UP-RL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
INSTP-F1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
INSTP-R1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of swing unit height: Fin-Y1
To adjust the height of the swing unit.
As the value is incremented by 1, the height of the swing unit is changed by angle of 0.1 degree.
+: Downward
-: Upward
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When misalignment occurs by failure of the paper feeding to processing tray.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-30 to 30
°
0
0.1
Adj front 1-stapling position: Fin-J1
To adjust the front 1-staple position.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in front/rear direction is displaced in the front 1-stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
Adj rear 1-stapling position: Fin-J1
To adjust the rear 1-staple position.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward rear
-: Toward front
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in front/rear direction is displaced in the rear 1-stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
856
8. Service Mode