Canon imageRUNNER ADVANCE 4551i Service Manual page 876

SORTER > ADJUST
SFT-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
STP-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
RBLT-PS2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
Adj dvry speed at collate mode: Fin-Y1
To adjust the delivery speed to the stack tray at collate mode.
As the value is changed by 1, the delivery speed changes by 10 mm/sec.
When the paper stacking of stack tray at collate mode is misalignment
Enter the setting value, and then press OK key.
- When the value is decreased, the productivity is decreased.
-5 to 5
mm/s
0
10
Adj dvry speed at staple mode: Fin-Y1
To adjust the delivery speed to the stack tray at staple mode or staple-free binding mode.
As the value is changed by 1, the delivery speed changes by 10 mm/sec.
When the paper stacking at staple mode or staple-free binding mode is misalignment
Enter the setting value, and then press OK key.
- When the value is decreased, the productivity is decreased.
- When the buffer operation is performed, delivery speed does not change. (The buffer operation
is the operation to deliver the stacking paper on the processing tray.)
The ON/OFF of buffer operation is set by BUFF-SW.
-5 to 5
mm/s
0
SORTER> OPTION> BUFF-SW
10
Adj of Return Belt height: Fin-Y1
To adjust the height of the Return Belt when aligning the paper on the processing tray.
As the value is changed by 1, the height of the return belt changes by angle of 0.1 degree.
+: Downward
-: Upward
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the misalignment of paper stack occurs during alignment operation on the processing tray.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value, and then press OK key.
The height of Return Belt during the paper alignment on the processing tray is the total of setting
values of RBLT-PRS and PBLT-PS2, so adjust again the setting value of RBLT-PS2 if necessary
when changing the setting value of RBLT-PRS.
After the setting value is changed, write the changed value in the service label.
-30 to 30
0
SORTER>ADJUST>RBLT-PRS
Perform this adjustment after executing adjustment of RBLT-PRS.
0.1
863
8. Service Mode