Canon imageRUNNER ADVANCE 4551i Service Manual page 752

COPIER > OPTION > NETWORK
WUEV-RTR 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
WUEN-LIV 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
IFX-CHIG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
Setting of sleep notification range
To set the number of available routers to the target for sleep notification.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
This is active when COPIER> OPTION> NETWORK> WUEV-SW is set to 0: Notified.
0 to 254
3
COPIER> OPTION> NETWORK> WUEV-SW
Recovery time setting after sleep notice
To set the time from the sleep start from network without job assignment until the mode is shifted
to the sleep mode.
When setting the startup time after sleep notification
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
10 to 600
sec
15
1
Set operation by IFAX recv mail content
To set the number of characters for the IFAX received mail content, so that the mail is not printed/
forwarded when the characters in the text is less than the number of specified characters.
This machine can output blank paper because some senders send e-mail text consists of linefeed
codes only. In such case, specify 2 (number of characters) so that there will be no output of blank
paper.
In the case of specifying any number other than 0, header/footer is printed/forwarded in 1 sheet
only if the e-mail (body) text is less than the specified value while no TIFF file is attached.
As the value is incremented by 1, the number of target characters in e-mail body text is increased
by 1 character.
When reducing print of blank paper due to e-mail received by IFAX
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to get approval from the user by telling that there will be no print of e-mail (body) text if
the number of characters is less than the specified value.
0 to 999
0: E-mail (body) text is not ignored.
char
0
1 Japanese Kanji character is calculated as 2 bytes, and the control codes (such as linefeed code,
etc) are included in the number of characters.
1
739
8. Service Mode