Canon imageRUNNER ADVANCE 4551i Service Manual page 867

SORTER > ADJUST
SDL-STP 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
SDL-FLD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
SDL-ALG 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of Saddle Sttch stpl pstn: Fin-Y1
To adjust the staple position of Saddle Stitcher.
As the value is incremented by 1, the staple position moves by 0.1mm.
+: The staple position moves toward the left at open page of the book
-: The staple position moves toward the right at open page of the book
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB,
enter the value of service label.
When the staple position of the Saddle Stitcher is displaced.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-20 to 20
mm
0
SORTER> ADJUST> SDL-STP2
Because the staple position of the thin paper is changed by this adjustment at the same time,
perform the adjustment of SDL-STP2 as needed after performing this adjustment if the staple
position of the thin paper has been adjusted by SDL-STP2.
0.1
Adj of Saddle Sttch fold pstn: Fin-Y1
To adjust the fold position of Saddle Stitcher.
As the value is incremented by 1, the fold position moves by 0.1 mm.
+: The staple position moves toward the left at open page of the book
-: The staple position moves toward the right at open page of the book
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB,
enter the value of service label.
When the fold position of the Saddle Stitcher is displaced
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-20 to 20
mm
0
SORTER> ADJUST> SDL-FLD2
Because the fold position of the thin paper is changed by this adjustment at the same time, perform
the adjustment of SDL-FLD2 as needed after performing this adjustment if the fold position of the
thin paper has been adjusted by SDL-FLD2.
0.1
Adj of Saddle Sttch align wid: Fin-Y1
To adjust the alignment width of Saddle Stitcher.
As the value is incremented by 1, the alignment width is increased by 0.1 mm.
+: The width of the adjustment plate becomes narrow.
-: The width of the adjustment plate becomes wide.
When the misalignment occurs within a paper stack on the Saddle Stitcher
Enter the setting value, and then press OK key.
-20 to 20
mm
0
0.1
854
8. Service Mode