Canon imageRUNNER ADVANCE 4551i Service Manual page 870

SORTER > ADJUST
NST-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FR-ST-PS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
FR-STP-X 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Supplement/Memo
Amount of Change per
Unit
Adj dvry speed at non-collate: Fin-Y1
To adjust the delivery speed to the stack tray in non-collate mode.
As the value is incremented by 1, the delivery speed is increased by 10 mm/sec.
When the stacking condition in non-collate mode is poor
Enter the setting value, and then press OK key.
-10 to 10
mm/s
0
10
Adjust staple free pressure: Fin-J1/Y1
To adjust the staple pressure in the staple free stapling mode.
As the value is changed by 1, the staple pressure changes by 1 mNm.
+: Increased
-: Decreased
Upon user's request (When changing the binding pressure)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
The life of staple-free binding unit becomes shorter when increasing the setting value.
-15 to 15
mNm
0
1
Adj stpl free stpl pstn (Fd way): Fin-J1
To adjust the staple position for paper feed direction in the staple free stapling mode.
As the value is changed by 1, the staple position moves by 0.1 mm.
+: Toward inlet direction
-: Toward delivery direction
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the staple position in paper feed direction is displaced in the staple free stapling mode
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
After the setting value is changed, write the changed value in the service label.
-15 to 15
mm
0
Change the paper shift amount in the paper feed direction. The staple free stapler position is not
changed.
0.1
857
8. Service Mode