Canon imageRUNNER ADVANCE 4551i Service Manual page 737

COPIER > OPTION > FNC-SW
AMSOFFSW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
UA-OFFSW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
MIB-NVTA
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
MIB-EXT
1 Enabling of AMS mode
To enable the AMS mode.
When 0 is set, the AMS mode is enabled. The AMS mode is automatically enabled when the
following 2 conditions are satisfied.
- AMS license for an iR option is installed.
- AMS-supported Login application (User Authentication, etc.) is activated.
When enabling AMS mode
1) Check that AMS-supported Login application is activated.
2) Enter 0, and then press OK key.
3) Turn OFF/ON the main power switch.
4) Check that [Role Management] is displayed on remote UI.
0 to 1
0: AMS mode enabled, 1: AMS mode disabled
1
COPIER> OPTION> LCNS-TR> ST-AMS
(Remote UI) User Management> Authentication Management> Role Management
AMS: Access Management System
In AMS mode, [Role Management] is displayed on remote UI.
1 ON/OFF of unified auth function
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set ON/OFF of the Unified Authentication function.
Set 0 when not preferring to use the Unified Authentication function because of security concern.
Upon user's request (not to use the Unified Authentication function)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
Unified Authentication: A function with which it is considered that login authentication under it is
performed by logging in it using SSO-H.
1 RFC-compatible character stringMIB write
As default, MIB object which NVT-ASCII can be written exists in order to link with LUI entry value.
This violates RFC order, so a problem like garbled 2-byte characters may occur in the SNMP
monitoring system, such as the 3rd vendor's MPS.
Whether non-RFC-compatible character strings are written in MIB can be set using this mode.
When 1 is set, only the character strings which are strictly compatible with RFC are written. (Writing
operation is executed from the SNMP manager.) LUI is not linked.
Upon user's request (operation with RFC-compatible system)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
0: Compatible in a conventional manner, 1: RFC-compatible, 2 to 3: Not used
0
RFC: Document of internet-related technical standards
NVT-ASCII: Network Virtual Terminal-ASCII
1 For R&D
724
8. Service Mode