Canon imageRUNNER ADVANCE 4551i Service Manual page 694

COPIER > ADJUST > FEED-ADJ
ADJ-RE-L 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
LOOP-THK 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
LOOP-SP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Side regist adj: 2-sided, large paper
To adjust the image reading start position in horizontal scanning direction for 2-sided print. (large
paper with 216mm or more in feed direction)
The image write start position is set in the relative amount against the first side regardless of the
paper pickup cassette/tray/deck.
As the value is incremented by 1, the left blank area changes by 0.1mm.
+: The left blank area becomes narrow. (The image shifts to left)
-: The left blank area becomes wide. (The image shifts to right)
When replacing the DC Controller PCB/clearing RAM data
In case of side registration adjustment at 2nd side (re-pickup) with large paper
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
mm
0
COPIER> ADJUST> FEED-ADJ> ADJ-REFE
The side registration in second side of the large paper is adjusted by the settings of the ADJ-REFE
and this mode.
0.1
Reg loop amnt adj: MP Tr fd of plain 3
To adjust the registration loop amount at multi-purpose tray pickup of plain paper 3 and bond paper
and postcard.
As the value in changed by 1, the paper feeding distance is increased or decreased by 0.1 mm.
+: The loop amount increases.
-: The loop amount decreases.
When the plain paper 3 and bond paper and postcard are skewed
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
mm
0
0.1
Reg loop amunt adj: MP Tr fd of spcl ppr
To adjust the registration loop amount at multi-purpose tray pickup of special paper.
As the value in changed by 1, the paper feeding distance is increased or decreased by 0.1 mm.
+: The loop amount increases.
-: The loop amount decreases.
When the special paper is skewed
Special paper is
Transparency, Thin paper 2, Label paper, Tracing paper
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-128 to 127
mm
0
0.1
681
8. Service Mode