Canon imageRUNNER ADVANCE 4551i Service Manual page 700

COPIER > ADJUST > MISC
C4-ADJ-Y 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
MF-ADJ-Y 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
DK-ADJ-Y 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ACS-EN2 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Enter Cassette4 side register adj value
As the value is changed by 1, the margin on the left edge of paper is increased or decreased by
0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When adjusting side registration of paper picked up from Cassette 4, when executing RAM clear
of the DC Controller PCB, or when replacing the PCB (Enter the value of service label.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Be sure to enter the adjustment value on the service label after adjustment.
-128 to 127
mm
0
0.1
Enter MP Tray side register adj value
As the value is changed by 1, the margin on the left edge of paper is increased or decreased by
0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When adjusting side registration of paper picked up from Multi-purpose Tray, when executing RAM
clear of the DC Controller PCB, or when replacing the PCB (Enter the value of service label.)
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Be sure to enter the adjustment value on the service label after adjustment.
-128 to 127
mm
0
0.1
Enter Paper Deck side register adj value
As the value is changed by 1, the margin on the left edge of paper is increased or decreased by
0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When adjusting side registration of paper picked up from Paper Deck, when executing RAM clear
of the DC Controller PCB, or when replacing the PCB (Enter the value of service label.)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Be sure to enter the adjustment value on the service label after adjustment.
-128 to 127
mm
0
0.1
Set ACS mode judgment area: stream read
To set the ACS judgment area either in the image on the front side stream read with DADF (1-path
model) or the images on both the front and back sides stream read with the DADF (reverse model).
As the value is larger, the judgment area is widened.
When adjusting the ACS judgment area at stream reading
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-2 to 2
1
687
8. Service Mode