Canon imageRUNNER ADVANCE 4551i Service Manual page 696

COPIER > ADJUST > CST-ADJ
MF-A6R 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
MF-A4 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
■ FIXING
COPIER > ADJUST > FIXING
FX-FL-SP 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of MP Tray A6R paper width
To adjust the width of A6R paper in the Multi-purpose Tray.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Multi-purpose Tray Paper Width Detection PCB or registering a new value,
execute COPIER> FUNCTION> CST> MF-A6R.
- When replacing the DC Controller PCB/clearing RAM data
- When replacing the Multi-purpose Tray paper Width Detection PCB or registering a new value
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
0 to 1024
118
COPIER> FUNCTION> CST> MF-A6R
Adj of MP Tray A4 paper width
To adjust the width of A4 paper in the Multi-purpose Tray.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When replacing the Multi-purpose Tray Paper Width Detection PCB or registering a new value,
execute COPIER> FUNCTION> CST> MF-A4.
- When replacing the DC Controller PCB/clearing RAM data
- When replacing the Multi-purpose Tray paper Width Detection PCB or registering a new value
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
0 to 1024
479
COPIER> FUNCTION> CST> MF-A4
Adj of fixing film speed at normal speed
To adjust the fixing film speed at the normal speed
When paper passes through the registration roller, the density difference occurs by slack/tension
of the paper on the image trailing edge (about 45mm).
When executing RAM clear of DC controller PCB/replacing the PCB
Select the item to be highlighted to enter the setting value (switch with +/- key), and then press OK
key.
-3 to 3
%
0
1
683
8. Service Mode