Canon imageRUNNER ADVANCE 4551i Service Manual page 471

614-4000-00
Detection Description
Remedy
614-4001-00
Detection Description
Remedy
614-4002-00
Detection Description
Remedy
614-4003-00
Detection Description
Remedy
614-4010-00
Detection Description
Remedy
614-4011-00
Detection Description
Remedy
Flash PCB error
The OS could not be recognized.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Flash PCB error
The OS boot file was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Flash PCB error
The OS kernel was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Flash PCB error
The OS boot loader was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Flash PCB error
The OS in safe mode could not be recognized.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Flash PCB error
The file for booting the OS in safe mode was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is properly installed.
2. Enter safe mode using (2+8) startup, and execute Flash Format using SST or a USB flash drive.
3. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
458
7. Error/Jam/Alarm