Canon imageRUNNER ADVANCE 4551i Service Manual page 537

04-1976 -
A. Operation / B. Cause /
C. Remedy
09-0013 -
A. Operation / B. Cause /
C. Remedy
10-0001 -
A. Operation / B. Cause /
C. Remedy
10-0020 -
A. Operation / B. Cause /
C. Remedy
10-0094 -
A. Operation / B. Cause /
C. Remedy
10-0100 -
A. Operation / B. Cause /
C. Remedy
10-0404 -
A. Operation / B. Cause /
C. Remedy
11-0001 -
A. Operation / B. Cause /
C. Remedy
11-0010 -
A. Operation / B. Cause /
C. Remedy
Receptacle error detection alarm: High Capacity Cassette
Cause: Error in the sensor in the receptacle
Detection condition/timing:
- When paper stack was not detected three times within the specified period of time while shifting
a paper stack
- When Right Deck paper loading detection failed three times although paper stack shift detection
was turned ON within the specified period of time while shifting a paper stack
- When the Division Plate detection failed three times although the Division Plate Solenoid was
turned ON while shifting a paper stack
- When the Lifter HP detection failed three times within the specified period of time while the Lifter
was moving to the HP
Movement/symptom: While failure has occurred (an alarm has occurred), the target paper source
cannot be used because it is in no paper state.
Measures:
- Check for any foreign matter in the receptacle.
- Check the connector and the cable connector of the receptacle.
- Check the motor, gear and timing belt for shifting paper stack in the receptacle.
- Check the Paper Stack Shift Sensor in the receptacle.
- Check the Division Plate Solenoid and the Division Plate Sensor in the receptacle.
- Check the Right Deck and the Lifter Sensor in the receptacle.
- Adjust the paper settings by referring to the Service Manual [High Capacity Cassette Pedestal >
Adjustment > Switching the Size between LTR and A4].
Method for clearing the alarm
1. Perform a remedy for the failure.
2. Place paper in the Left Tray with no paper in the Right Tray, and close the receptacle.
The alarm is cleared when shifting of stack is performed normally.
3. Press the [Status Monitor/Cancel] key, and check that the status of the Cassette 3 is "paper
present".
Drum memory detection error
Cause: The memory of the Drum Unit could not be detected.
Toner Low (Black) alarm
Low toner was detected and UGW generated an alarm.
* Not displayed on service mode history due to the alarm being generated by UGW
Toner cartridge prior delivery alarm
An alarm for requesting a prior delivery is sent to UGW as the value of Toner level detect value
has reached the value set in COPIER > OPTION > FNC-SW > T-DLV-BK.
Toner memory detection alarm (Bk)
Cause: Memory of toner could not be detected.
Toner cartridge replace notice
The replacement of the Toner Cartridge was detected.
Toner Bottle empty alarm
When the Toner Bottle empty was detected
Waste Toner Container full
Movement: A message "The waste toner container is full." is displayed on the Control Panel, and
the machine is stopped.
Cause: The Waste Toner Container becomes full.
Measures: Clean the Waste Toner Container.
Waste toner container near full
Movement: Displayed a message by an operation panel (A continuation print is possible)
Cause: The capacity of the Waste Toner Container became near full.
524
7. Error/Jam/Alarm