Canon imageRUNNER ADVANCE 4551i Service Manual page 774

COPIER > OPTION > IMG-FIX
EDG-WAIT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TMP-TBL9 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TMP-TB10 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TMP-TBLC 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
Change of Detection Temp for Fixing Edge
To change the detection temperature of the fixing sub thermistors 1/2 to switch the paper edge
cooling fans to the full speed control, and to shift the machine control to the down sequence
To reduce the switching frequency of the down sequence, to lower the fixing edge temperature,
and to prevent the high temperature offset
Enter the setting value, and then press OK key.
0 to 4
0: +20 deg C, 1: +10 deg C, 2: 0 deg C, 3: -10 deg C, 4: -20 deg C
2
Set fix control temp table:Pln 1/Cst,MP
To change the fixing control temperature in the plain paper 1 mode at the cassette feeding of the
25/35/45/51 cpm machine and the Multi-Purpose Tray feeding of the 25 cpm machine.
When the poor fixing, paper slip or paper curl occurs in the plain paper 1 mode
Enter the setting value, and then press OK key.
(Fixing grade priority)
0 to 2: +15 deg C
3 to 6: +12 to +3 deg C (3 deg C unit)
7: OFF
8 to 11: -3 to -12 deg C (3 deg C unit)
12 to 14: -15 deg C
(Productivity priority)
7
Set fix control temp table:Pln 1/MP-tray
To change the fixing control temperature in the plain paper 1 mode at the Multi-Purpose Tray of
the 35/45/51 cpm machine.
When the poor fixing, paper slip or paper curl occurs in the plain paper 1 mode at the Multi-purpose
Tray
Enter the setting value, and then press OK key.
(Fixing grade priority)
0 to 2: +15 deg C
3 to 6: +12 to +3 deg C (3 deg C unit)
7: OFF
8 to 11: -3 to -12 deg C (3 deg C unit)
12 to 14: -15 deg C
(Productivity priority)
7
Set fixing control tmp table: curled ppr
To set the control temperature table to the N1 mode or the N3 mode so that the paper curl is
reduced when select the thin paper 1 and the plain paper 1/2. And transfer bias is set as the
following.
Transfer leading edge weak bias is ON or Transfer leading edge bias is OFF.
When the paper is moist so that the paper curl occurs
Enter the setting value, and then press OK key.
0 to 3
0: Auto
1: OFF
2: N1 mode with thin paper 1 and plain paper 1/2 (Target temperature becomes low.)
3: N3 mode with thin paper 1 and plain paper 1/2 (Target temperature becomes moreover low.)
The default differs according to the location.
When the setting value is "0", change the normal temperature control and the N1 mode depending
on environment (temperature/humidity). N3 mode is only hand-operated setting.
761
8. Service Mode