Canon imageRUNNER ADVANCE 4551i Service Manual page 868

SORTER > ADJUST
ST-ALG1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ST-ALG2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj Stacker A4 align pstn: Fin-Y1
To adjust the A4 size paper alignment position of the Process Tray.
As the value is incremented by 1, the position of the adjustment plate is increased by 0.1 mm.
+: Inward
-: Outward
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB,
enter the value of service label.
When misalignment occurs in A4 size paper.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
1) Enter the setting value, and then press OK key.
2) The alignment plate moves to position of the A4 width.
3) Set the A4 paper on the processing tray.
4) Enter the setting value, and then press OK key.
5) Check the adjustment movement of the alignment plate.
6) Repeat steps 4) and 5) and adjust alignment width.
7) After completion of the adjustment, remove paper on the processing tray.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
Adj Stacker LTR align pstn: Fin-Y1
To adjust the LTR size paper alignment position of the Process Tray.
As the value is incremented by 1, the position of the adjustment plate is increased by 0.1 mm.
+: Inward
-: Outward
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When misalignment occurs in LTR size paper.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
1) Enter the setting value, and then press OK key.
2) The alignment plate moves to position of the LTR width.
3) Set the LTR paper on the processing tray.
4) Enter the setting value, and then press OK key.
5) Check the adjustment movement of the alignment plate.
6) Repeat steps 4) and 5) and adjust alignment width.
7) After completion of the adjustment, remove paper on the processing tray.
After the setting value is changed, write the changed value in the service label.
-50 to 50
mm
0
0.1
855
8. Service Mode