Canon imageRUNNER ADVANCE 4551i Service Manual page 739

COPIER > OPTION > FNC-SW
BXSHIFT 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
HOME-SW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
NO-LGOUT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
T-DLV-BK 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
Setting of binding at 0mm binding margin
To set whether to judge the job as a job "without binding" when storing a PDL job in Inbox while
the binding margin is set to "0".
By setting the binding margin to 0 mm while "0" is set, the job is processed as "without binding".
"Booklet" in "Options" on the Inbox screen can be also used.
When "1" is set, it is judged as "with binding" even the binding margin is 0 mm so "Booklet", which
has an exclusive relationship with "binding", cannot be used.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When storing a PDL job in Inbox while 1 is set, "Booklet" in "Options" on the Inbox screen cannot
be used.
0 to 1
0: Without binding, 1: With binding
0
Set screen displayed with Main Menu key
To set whether to display the main menu screen or the screen registered as the startup screen
when pressing Main Menu key.
Upon user's request (to change the startup screen)
Enter the setting value, and then press OK key.
0 to 1
0: Main Menu screen, 1: Screen registered as the startup screen
0
Display/hide of logout button
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to display or hide [Logout] button.
When 0 is set, [Logout] button is displayed on the screen, and logout with the ID key is enabled.
(Normal)
When 1 is set, [Logout] button is not displayed, and logout with the ID key is disabled.
Upon user's request (for customization, etc.)
Enter the setting value, and then press OK key.
0 to 1
0: Display, 1: Hide
0
Set of toner level to send the alarm
To set toner level to send the pre-toner low alarm.
When changing the timing to notify the end of life according to the usage status
Enter the setting value, and then press OK key.
Since toner level is calculated based on the developing supply count, some errors may occur.
0 to 40
It differs according to the location.
1
726
8. Service Mode