Canon imageRUNNER ADVANCE 4551i Service Manual page 862

FEEDER > FUNCTION
SL-CHK 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
SL-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
MTR-ON 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
ROLL-CLN 1
Detail
Use Case
Adj/Set/Operate Method
FEED-ON 1
Detail
Use Case
Adj/Set/Operate Method
Related Service Mode
Specification of DADF operation solenoid
To specify the solenoid of DADF to operate.
The solenoid is activated by SL-ON.
At operation check
Enter the setting value, and then press OK key.
0 to 1
- Single Pass DADF
0: Stamp Solenoid (SL1)
1: -
- Reversal DADF
0: Release Solenoid (SL1)
1: Stamp Solenoid (SL2)
0
FEEDER> FUNCTION> SL-ON
Operation check of DADF solenoid
To start operation check of the solenoid specified by SL-CHK.
At operation check
1) Select the item, and then press OK key.
It is driven for approximately 5 seconds and is automatically stopped.
2) Press OK key.
The operation check is completed.
Be sure to press the OK key again after execution. The operation automatically stops after
approximately 5 seconds, but is not completed unless the OK key is pressed (STOP is not
displayed).
FEEDER> FUNCTION> SL-CHK
Operation check of DADF motor
To start operation check for the motor specified by MTR-CHK.
At operation check
1) Select the item, and then press OK key.
The unit operates for approximately 5 seconds and automatically stops.
2) Press OK key.
The operation check is completed.
Be sure to press the OK key again after execution. The operation automatically stops after
approximately 5 seconds, but is not completed unless the OK key is pressed (STOP is not
displayed).
FEEDER> FUNCTION> MTR-CHK
Rotation of DADF rollers
To rotate the rollers of DADF for cleaning.
Check the rollers with lint-free paper moistened with alcohol while they are rotating.
When cleaning the rollers
1) Select the item, and then press OK key.
2) Clean the rotating rollers with lint-free paper moistened with alcohol.
3) Press OK key.
The rollers stop.
Operation check of DADF individual feed
To start operation check of the feed mode specified by FEED-CHK.
At operation check
Select the item, and then press OK key.
FEEDER> FUNCTION> FEED-CHK
849
8. Service Mode