Canon imageRUNNER ADVANCE 4551i Service Manual page 875

SORTER > ADJUST
SDL-STP2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
SDL-FLD2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
ESC1-SPD 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj of Saddle Sttch stpl pstn: Fin-Y1
To adjust the staple position of Saddle Stitcher (when using the thin paper; the paper that the paper
weight is less than 64 g/m2).
As the value is incremented by 1, the staple position moves by 0.1mm.
+: The staple position moves toward the left at open page of the book
-: The staple position moves toward the right at open page of the book
When the staple position of the Saddle Stitcher is displaced with the thin paper
Enter the setting value, and then press OK key.
-20 to 20
mm
0
SORTER> ADJUST> SDL-STP
Perform this adjustment after performing the adjustment of SDL-STP.
Because the staple position of the thin paper is adjusted by the total setting values of SDL-STP
and SDL-STP2, the actual adjustment of the staple position is performed in the staple position
adjustable range (-20 to 20) even if entering the setting value beyond the mechanical staple
position adjustable range.
0.1
Adj of Saddle Sttch fold pstn: Fin-Y1
To adjust the fold position of Saddle Stitcher (when using the thin paper; the paper that the paper
weight is less than 64 g/m2).
As the value is incremented by 1, the fold position moves by 0.1 mm.
+: The fold position moves toward the left at open page of the book
-: The fold position moves toward the right at open page of the book
When the fold position of the Saddle Stitcher is displaced with the thin paper
Enter the setting value, and then press OK key.
-20 to 20
mm
0
SORTER> ADJUST> SDL-FLD
Perform this adjustment after performing the adjustment of SDL-FLD.
Because the fold position of the thin paper is adjusted by the total setting values of SDL-FLD and
SDL-FLD2, the actual adjustment of the fold position is performed in the fold position adjustable
range (-20 to 20) even if entering the setting value beyond the mechanical fold position adjustable
range.
0.1
Adj Escape Tr delivery speed: Fin-Y1
To adjust the delivery speed to the escape tray.
As the value is changed by 1, the delivery speed to the lower escape tray changes by 10 mm/sec.
When the paper stacking to the escape tray is misalignment
Enter the setting value, and then press OK key.
-10 to 10
mm/s
0
10
862
8. Service Mode