Function - Canon imageRUNNER ADVANCE 4551i Service Manual

COPIER > ADJUST > MISC
ACS-EN3 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ACS-CNT3 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value

FUNCTION

■ INSTALL
COPIER > FUNCTION > INSTALL
TONER-S 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ACS mode judgmt area:stream, bck, 1-path
To set the ACS judgment area in the image on the back side stream read with the DADF (1-path
model).
As the value is larger, the judgment area is widened.
The setting of this item is enabled only when the DADF (1-path model) is installed.
When adjusting the ACS judgment area in the image on the back side at stream reading
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
-2 to 2
1
Chromatic clr jdgmt area:strem,bck,1path
To set the area to judge whether the image on the back side stream read with DADF (1-path model)
is color or B&W at automatic color selection.
As the value is larger, the judgment area is widened.
The setting of this item is enabled only when the DADF (1-path model) is installed.
When adjusting the area where the pixel is counted to judge whether it is a color/B&W image
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
-2 to 2
0
Toner supply to Developing Assembly
To execute a series of operation necessary for supplying toner to the Developing Assembly/Toner
Supply area (drive the Developing Cylinder, Toner Stirring/Feed Member) as a whole.
After counting down from 600 seconds, it is stopped automatically.
- At installation
- When replacing the Developing Assembly
- When replacing toner in the Developing Assembly
1) Select the items.
"Check the Developer" is displayed.
2) Check connection, and then press OK key.
It automatically stops after 10 minutes.
- Although "Check the Developer" is displayed when selecting the item, be sure to check the
connection between the Developing Assembly and connector.
- The operation can stop manually with OK key when a failure occurs.
During operation: xxx second (remaining time), When operation finished normally: OK!
600
689
8. Service Mode