Canon imageRUNNER ADVANCE 4551i Service Manual page 791

COPIER > OPTION > USER
IFAX-PGD 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Supplement/Memo
MEAPSAFE 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PRNT-POS 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
AFN-PSWD 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set page split TX at IFAX Simple mode TX
To set to enable/disable split-data transmission on a page basis in the case that the transmission
size in IFAX Simple mode exceeds the upper limit value.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
In the case to enable split-data transmission, be sure to get approval from the user by explaining
the following:
- No guarantee for page order on the reception side
- There is a possibility of interruption of other received jobs between pages.
0 to 1
0: Disabled, 1: Enabled
0
COPIER> OPTION> CLEANING> W-CLN-P
Function Settings> Send> E-Mail/I-Fax Settings> Maximum Data Size for Sending
Set the upper limit value for transmission data size in Settings/Registration menu.
Setting of MEAP safe mode
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set safe mode for MEAP platform.
MPSF is displayed on the Control Panel in safe mode.
In safe mode, MEAP application is stopped while just the system application, which starts with
initial state, is activated. Logs for cause analysis of MEAP failure can be obtained.
Perform system recovery processing when MEAP platform fails to be activated due to resource
confliction between MEAP applications, service registration or use order.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Normal mode, 1: Safe mode
0
ON/OFF of all pauses at error job cancel
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to pause the print operation of following jobs when a job is canceled due to an error
inside the machine (#037, etc.) except service calls during PDL print.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
0
Setting of Set/Reg menu access limit
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set restriction on accessing Settings/Registration menu by entering password.
With the setting to enable this mode, password entry of system administrator is required after
pressing Settings/Registration key.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Password is not required, 1: Password is required
0
778
8. Service Mode