Canon imageRUNNER ADVANCE 4551i Service Manual page 733

COPIER > OPTION > FNC-SW
CARD-RNG
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SJOB-CL
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
MIBCOUNT
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
CNTR-SW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
W/RAID
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
2 Card number setting (department number)
To set the number of cards (departments) that can be used with the Card Reader.
When setting the number of cards (departments)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 1000
1000
1 Set of scan job canceling by logout
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to cancel the scan job in operation by logout of the user.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
The job with scanning completed cannot be canceled.
0 to 2
0: Cancel only scan job in waiting state, 1: Cancel all scan jobs, 2: Not canceled
0
Scan job: A job after the scanning operation is completed.
2 Scope range set of Charge Counter MIB
To set the range of counter information that can be obtained as MIB (Management Information
Base).
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: All charge counters are obtained, 1: Only displayed counter* is obtained, 2: All charge counters
are not obtained
* : Counter specified by the following: COPIER> OPTION> USER> COUNTER 1 to 6
0
COPIER> OPTION> USER> COUNTER1 - 6
1 Init of parts counter replacement timing
To return the estimated life of parts counter to the initial value.
If either "00000000" or a value before the specification change is displayed in the estimated life
value of the parts counter, set 0 after upgrading of the firmware.
- When either "00000000" or a value before the specification change is displayed in the estimated
life value of the parts counter
- When changing the state back to the initial state after entering the estimated life value manually
1) Enter 0, and then press OK key.
2) Turn OFF/ON the main power switch.
0: Returned to the initial value
0
1 Set of HDD Mirroring Kit installation
To set installation condition of HDD Mirroring Kit.
Select "1: Installed" when installing the HDD Mirroring Kit. Select "0: Not installed" when removing
the HDD Mirroring Kit.
When installing/removing HDD Mirroring Kit
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not installed, 1: Installed
0
720
8. Service Mode