Canon imageRUNNER ADVANCE 4551i Service Manual page 442

5F6-8001-02
Detection Description
Remedy
5F6-8002-02
Detection Description
Remedy
Error in the Saddle Paper Pushing Plate/Folding Motor (Finisher-Y1)
The saddle paper pushing plate does not come off the Saddle Paper Pushing Plate HP Sensor
when the Saddle Paper Pushing Plate/Folding Motor has been driven for 1 second.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Saddle Paper Pushing Plate HP Sensor (PS208) to the Saddle Stitcher
Controller PCB
- Harnesses from the Saddle Paper Pushing Plate/Folding Motor (M204) to the Saddle Stitcher
Controller PCB
- Saddle Paper Pushing Plate HP Sensor (PS208)
- Saddle Paper Pushing Plate/Folding Motor (M204)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the malfunction in the swing guide unit.
2. Check whether there is not the malfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Saddle Paper Pushing Plate/Folding Motor (Finisher-Y1)
The Saddle Paper Pushing Plate HP Sensor does not detect the saddle paper pushing plate when
the Saddle Paper Pushing Plate/Folding Motor has been driven for 3 seconds.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Saddle Paper Pushing Plate HP Sensor (PS208) to the Saddle Stitcher
Controller PCB
- Harnesses from the Saddle Paper Pushing Plate/Folding Motor (M204) to the Saddle Stitcher
Controller PCB
- Saddle Paper Pushing Plate HP Sensor (PS208)
- Saddle Paper Pushing Plate/Folding Motor (M204)
- Saddle Stitcher Controller PCB (PCB201)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the malfunction in the swing guide unit.
2. Check whether there is not the malfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
429
7. Error/Jam/Alarm