Canon imageRUNNER ADVANCE 4551i Service Manual page 872

SORTER > ADJUST
RBLT-PRS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
Adj return belt pressure: Fin-J1/Y1
To adjust the amount of pressure of the Return Belt.
Fin-J1
As the value is changed by 1, the Return Belt is moved up or down by 0.1 mm so the amount of
pressure is increased or decreased.
+: Increase
-: Decrease
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
Fin-Y1
As the value is changed by 1, the Return Belt is moved up or down by 0.1 degrees so the amount
of pressure is increased or decreased.
+: Increase
-: Decrease
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser
Controller PCB, enter the value of service label.
When the paper alignment position is displaced.
When replacing the Finiser Controller PCB/clearing the RAM data of the Finiser Controller PCB.
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Fin-J1:
After the setting value is changed, write the changed value in the service label.
Fin-Y1:
The height of Return Belt during the paper alignment on the processing tray is the total of setting
values of RBLT-PRS and PBLT-PS2, so adjust again the setting value of RBLT-PS2 if necessary
because the height of Return Roller during the paper alignment on the processing tray changes
too by changing the setting value of RBLT-PRS.
After the setting value is changed, write the changed value in the service label.
Fin-J1: -10 to 10
Fin-Y1: -100 to 50
mm
0
Fin-Y1:
SORTER> ADJUST> RBLT-PS2
Fin-Y1:
The height of Return Belt when stacking the first sheet of paper or buffering the paper: The height
of Return Belt is double of the setting value. (Escape position of Return Belt)
The height of Return Belt when stacking the sheet of paper except for first sheet: The height of
Return Belt is the setting value. (Paper feed position of Return Belt)
0.1
859
8. Service Mode