Settings For Teach-In - Siemens SINUMERIK Series Operating Manual

Teaching in a program

17.8 Settings for teach-in

17.8 Settings for teach-in
In the "Settings" window, you define which axes are to be included in the teach-in block and
whether motion-type and continuous-path mode parameters are to be provided.
Proceed as follows
860
1. Select the "Machine" operating area.
2. Press the <AUTO> or <MDA> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
5. Press the ">>" and "Settings" softkeys.
The "Settings" window appears.
6. Under "Axes to be taught" and "Parameters to be taught", select the check
boxes for the relevant settings and press the "Accept" softkey to confirm
the settings.
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Milling