Siemens SINUMERIK Series Operating Manual page 606

Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Parameters in the "Input complete" mode
G code program parameters
Input
PRG Name of the program to be generated
PL Machining plane
RP Retraction plane – (only for
machining direction, longitu‐
dinal, inner)
SC Safety clearance
F Feedrate
Residual With subsequent residual material removal.
material
● Yes
● No
CONR Name to save the updated unmachined-part
contour for residual material removal - (only
"Yes" for residual material removal).
Parameter Description
TC Name of the swivel data set
Note: The selection box only appears if more than one swivel data set has been set up.
Retraction ● No
(for ShopMill pro‐
gram)
● Z
● Z,X,Y
● Tool direction, max.
● Tool direction, inc.
When retracting in the tool direction, in the swiveled machine state, several axes can
move (traverse).
606
● Complete
mm
mm
*
The axis is not retracted before swiveling.
Retraction in the direction of machine axis Z.
Move machining axes to retraction position before swiveling.
Maximum retraction (up to the software end position) in the tool direction.
Incremental retraction (specified retraction distance, up to the software end position)
in the tool direction.
ShopMill program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or
constant cutting rate
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
mm/min
mm/rev
rpm
m/min
Unit
Milling