Reactivating A Tool - Siemens SINUMERIK Series Operating Manual

Icon/
Marking
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow
(configurable)
Red "X"
Procedure
See also
Displaying tool details (Page 723)
Changing a tool type (Page 727)
13.6.1

Reactivating a tool

You can replace disabled tools or make them ready for use again.
Preconditions
In order to reactivate a tool, the monitoring function must be activated and a setpoint must be
stored.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. Select the "Parameter" operating area.
2. Press the "Tool wear" softkey.
Meaning
The tool is in a special state.
Place the cursor on the marked tool. A tooltip provides a
short description.
The tool is preselected.
The magazine location is positioned at the change position.
The magazine location is positioned at the loading position.
The magazine location is disabled.
Tool management
13.6 Tool wear
715