Multi-Channel View In The "Machine" Operating Area - Siemens SINUMERIK Series Operating Manual

Multi-channel view

11.2 Multi-channel view in the "Machine" operating area

11.2 Multi-channel view in the "Machine" operating area
With a multi-channel machine, you have the option of simultaneously monitoring and
influencing the execution of several programs.
Displaying the channels in the "Machine" operating area
In the "Machine" operating area, you can display 2 - 4 channels simultaneously.
Using the appropriate settings, you can define the sequence in which channels are displayed.
Here, you can also select if you wish to hide a channel.
Note
The "REF POINT" operating mode is shown only in the single-channel view.
Multi-channel view
2 - 4 channels are simultaneously displayed in channel columns on the user interface.
● Two windows are displayed one above the other for each channel.
● The actual value display is always in the upper window.
● The same window is displayed for both channels in the lower window.
● You can select the display in the lower window using the vertical softkey bar.
The following exceptions apply when making a selection using the vertical softkeys:
– The "Actual values MCS" softkey switches over the coordinate systems of both channels.
– The "Zoom actual value" and "All G functions" softkeys switch into the single-channel
Single-channel view
If you only wish to monitor one channel for your multi-channel machine, then you can set a
permanent single-channel view.
Horizontal softkeys
● Block search
When selecting the block search, the multi-channel view is kept. The block display is
displayed as search window.
● Program control
The "Program Control" window is displayed for the channels configured in the multi-channel
view. The data entered here applies for these channels together.
● If you press an additional horizontal softkey in the "Machine" operating area (e.g.
"Overstore", "Synchronized actions"), then you change into a temporary single-channel
view. If you close the window again, then you return to the multi-channel view.
672
Machine manufacturer
Please observe the information provided by the machine manufacturer.
view.
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Milling