Siemens SINUMERIK Series Operating Manual page 569

Parameter
X0
Z0
P0
X1 or
X1α
Z1
P1
X2 or
X2α
Z2
P2
X3
Z3
LW
LR
H1
DP or
αP
D1 or ND
rev
NN
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Description
Reference point X from thread table ∅ (abs)
Reference point Z (abs)
Thread pitch 1
● Intermediate point 1 X ∅ (abs) or
● Intermediate point 1 in relation to X0 (inc) or
● Thread taper 1
Incremental dimensions: The sign is also evaluated.
● Intermediate point 1 Z (abs) or
● Intermediate point 1 in relation to Z0 (inc)
Thread pitch 2 (unit as parameterized for P0)
● Intermediate point 2 X ∅ (abs) or
● Intermediate point 2 in relation to X0 (inc) or
● Thread taper 1
Incremental dimensions: The sign is also evaluated
● Intermediate point 2 Z (abs) or
● Intermediate point 2 in relation to Z0 (inc)
Thread pitch 3 (unit as parameterized for P0)
● End point X ∅ (abs) or
● End point 3 in relation to X2 (inc) or
● Thread taper 3
● End point Z ∅ (abs) or
● End point with reference to Z2 (inc)
Thread advance (inc)
Thread run-out (inc)
Thread depth
Infeed slope flank (inc) or infeed slope (angle)
● Infeed along a flank
● Infeed with alternating flanks
First infeed depth or number of roughing cuts - (only for ∇ and ∇ + ∇∇∇)
Finishing allowance in X and Z – (only for ∇ and ∇ + ∇∇∇)
Number of noncuts - (only for ∇∇∇ and ∇ + ∇∇∇)
Programming technological functions (cycles)
10.4 Turning - milling/turning machine
Unit
mm
mm
mm
mm
Degrees
mm
mm/rev
in/rev
turns/"
MODULUS
mm
Degrees
mm
mm/rev
in/rev
turns/"
MODULUS
mm
Degrees
mm
mm
mm
mm
mm
Degrees
mm
mm
569