Siemens SINUMERIK Series Operating Manual page 623

Parameter
XA
XB
ZA
ZB
N
DP
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
PRG Name of the program to be generated
Parameter Description
TC Name of the swivel data set
Note: The selection box only appears if more than one swivel data set has been set up.
Retraction
● No
(for ShopMill pro‐
gram)
● Z
● Z,X,Y
● Tool direction, max.
● Tool direction, inc.
When retracting in the tool direction, in the swiveled machine state, several axes can
move (travel).
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Description
With limited machining area only, yes:
1st limit XA ∅
2nd limit XB ∅ (abs) or 2nd limit referred to XA (inc)
1st limit ZA
2nd limit ZB (abs) or 2nd limit referred to ZA (inc)
Number of grooves
Distance between grooves
● simple
The axis is not retracted before swiveling
Retraction in the direction of machine axis Z
Move machining axes to retraction position before swiveling
Maximum retraction (up to the software end position) in the tool direction
Incremental retraction (specified retraction distance, up to the software end position)
in the tool direction
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
ShopMill program parameters
T Tool name
D Cutting edge number
S / V Spindle speed or
constant cutting rate
Unit
mm
mm
rpm
m/min
Unit
623