Tool Management; Lists For The Tool Management - Siemens SINUMERIK Series Operating Manual

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Tool management

All tools and also all magazine locations that have been created or configured in the NC are

displayed in the lists in the Tool area.

All lists display the same tools in the same order. When switching between the lists, the cursor

remains on the same tool in the same screen segment.

The lists have different parameters and softkey assignments. Switching between lists is a

specific change from one topic to the next.

All parameters and functions required to create and set up tools are displayed.

All parameters and functions that are required during operation, e.g. wear and monitoring

functions, are listed here.

You will find the magazine and magazine location-related parameters and functions for the

tools/ magazine locations here.

● Tool data OEM

This list can be freely defined by the OEM.

Sorting the lists

You can change the sorting within the lists:

● acc. to the magazine

● acc. to the name (tool identifier, alphabetic)

● according to the tool type

● according to the T number (tool identifier, numerical)

● According to D number

Filtering the lists

You can filter the lists according to the following criteria:

● only display the first cutting edge

● only tools that are ready to use

● only tools that have reached the pre-alarm limit

● only locked tools

● Only tools with active code

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0