Siemens SINUMERIK Series Operating Manual page 594

Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Parameter Description
UZ Finishing allowance in Z – (only for UX)
DI For zero: Continuous cut - (only for ∇)
BL Blank description (only for ∇)
● Cylinder (described using XD, ZD)
● Allowance (XD and ZD on the finished part contour)
● Contour (additional CYCLE62 call with blank contour – e.g. cast iron mold)
XD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
ZD - (only for ∇ machining)
- (only for blank description, cylinder and allowance)
● For blank description, cylinder
● For blank description, allowance
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
● No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is retained
● Negative value: Compensation allowance is removed in addition to finishing
Set machining area Set machining area limits
limits
● Yes
● No
With limited machining area only, yes:
XA 1. Limit XA ∅
XB 2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1. Limit ZA
ZB 2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
594
– Version, absolute:
Cylinder dimension ∅ (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
– Version, absolute:
Cylinder dimension (abs)
– Version incremental:
Allowance (inc) to maximum values of the CYCLE62 finished part contour
– Allowance on the CYCLE62 finished part contour (inc)
U1 contour allowance
allowance
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
mm
mm
mm
mm
mm
Milling