Siemens SINUMERIK Series Operating Manual page 382

Programming technological functions (cycles)
10.1 Drilling
Parameter Description
V3 Clearance distance
(only for stock re‐
moval and "man‐
ual" clearance dis‐
tance)
DTB -
● Dwell time at drilling depth in seconds
(only G code)
● Dwell time at drilling depth in revolutions
DT
● Dwell time at final drilling depth in seconds
● Dwell time at final drilling depth in revolutions
DTS - (only for ● Dwell time for swarf removal in seconds
stock removal)
● Dwell time for swarf removal in revolutions
(only G code)
Parameters in the "Input simple" mode
G code program parameters
Input
RP Retraction plane
Parameter Description
Machining
● Single position
position
● Position pattern
Machining
● Swarf removal
● Chip breaking
Z0 (only for G code) Reference point Z
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
D - (only for G code) First drilling depth (abs) or first drilling depth in relation to Z0 (inc)
D - (only for Shop‐ Maximum depth infeed
Mill)
382
● simple
mm
Drill hole at programmed position.
Position with MCALL
The drill is retracted from the workpiece for swarf removal.
The drill is retracted by the retraction distance V2 for chip breaking.
ShopMill program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
s
rev
s
rev
s
rev
mm/min
mm/rev
rpm
m/min
mm
mm
mm
Milling