Selection Of The Cycles Via Softkey - Siemens SINUMERIK Series Operating Manual

9.15

Selection of the cycles via softkey

Overview of machining steps
The following machining steps are available for insertion.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
⇒
⇒
⇒
⇒
⇒
⇒ ⇒
Creating a ShopMill program
9.15 Selection of the cycles via softkey
345