Siemens SINUMERIK Series Operating Manual page 602

Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Parameter Description
C1 The required angle can be freely entered.
(for ShopMill pro‐
gram)
αC Rotational position for a pole position.
(for ShopMill pro‐
gram)
Hirth joint
● Round to the next Hirth joint
● Round up to Hirth joint
● Round down to Hirth joint
Note:
For machines with a Hirth joint
Tool Tool tip when swiveling
● Tracking
The position of the tool tip is maintained during swiveling.
● No tracking
The position of the tool tip is not maintained during swiveling.
Preferred direc‐ Preferred direction of the swivel axis for several possible alignments of the machine.
tion (for ShopMill
program)
Machining
● ∇ (roughing)
● ∇∇∇ (finishing)
Machining
● Face
direction
● Longitudinal
● Parallel to the contour
The machining direction depends on the stock removal direction and choice of tool.
Position
● Front
● Rear
● Inside
● Outside
D Maximum depth infeed - (only for ∇)
XDA First grooving limit tool (abs) – (only for face machining direction).
XDB Second grooving limit tool (abs) – (only for face machining direction).
602
● From inside to outside
● From outside to inside
● From end face to rear side
● From rear side to end face
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
Degrees
Degrees
mm
mm
mm
Milling