Siemens SINUMERIK Series Operating Manual page 375

Parameters in the "Input complete" mode
G code program parameters
Input
PL Machining plane
RP Retraction plane
SC Safety clearance
Parameter Description
Machining posi‐
● Single position
tion (only for G
Drill hole at programmed position
code)
● Position pattern
Position with MCALL
Z0 (only for G Reference point Z
code)
Drilling depth
● Shank (drilling depth in relation to the shank)
The drill is inserted into the workpiece until the drill shank reaches the value
programmed for Z1. The angle entered in the tool list is taken into account.
● Tip (drilling depth in relation to the tip)
The drill is inserted into the workpiece until the drill tip reaches the value programmed
for Z1.
Z1 Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1.
Predrilling
● Yes
● No
ZA - (only for pre‐ Predrilling depth (abs) or predrilling depth in relation to the reference point (inc)
drilling "yes")
FA - (only for pre‐ Reduced predrilling feedrate as a percentage of the drilling feedrate
drilling "yes")
Predrilling feedrate (ShopMill)
Predrilling feedrate (G code)
Through drilling
● Yes
Through drilling with feedrate FD
● No
ZD - (only for Depth for feedrate reduction (abs) or depth for feedrate reduction in relation to Z1 (inc)
through drilling
"yes")
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
ShopMill program parameters
● complete
T
mm D
mm F
S / V
Programming technological functions (cycles)
Tool name
Cutting edge number
Feedrate
Spindle speed or constant cutting
rate
10.1 Drilling
mm/min
mm/rev
rpm
m/min
Unit
mm
mm
mm
mm/min
%
mm/min or
mm/rev.
Distance/
min or dis‐
tance/rev
mm
375