Siemens SINUMERIK Series Operating Manual page 400

Programming technological functions (cycles)
10.1 Drilling
Parameter Description
D Maximum depth infeed - (only when used without compensating chuck, swarf removal
or chip breaking)
Retraction Retraction distance - (for chip breaking only)
● Manual
Retraction distance after each machining step (V2)
● Automatic
The tool is retracted by one revolution.
V2 Retraction distance after each machining step – (only without compensating chuck, chip
breaking and manual retraction)
Distance by which the drill is retracted for chip breaking.
DT (for ShopMill, Dwell time in seconds:
only in the "with
● without compensating chuck
compensating
–
chuck without en‐
coder" mode)
–
–
● with compensating chuck
–
–
SR (only for G Spindle speed for retraction - (only for when a compensating chuck is not used)
code)
SDE (only for G Direction of rotation after end of cycle:
code)
●
●
●
Technology Adapting the technology:
● Yes
–
–
–
–
● No
Note:
The technology fields are only displayed if their display has been enabled.
Please observe the information provided by your machine manufacturer.
Exact stop (only ● Empty: Behavior the same as it was before the cycle was called
for technology,
● G601: Block advance for exact stop fine
yes)
● G602: Block advance for exact stop coarse
● G603: Block advance if the setpoint has been reached
Precontrol (only ● Empty: Behavior the same as it was before the cycle was called
for technology,
● FFWON: with precontrol
yes)
● FFWOF: without precontrol
400
1 cut: Dwell time at final drilling depth
Chip breaking: Dwell time at drilling depth
Swarf removal: Dwell time at the drilling depth and after retraction
with encoder: Dwell time after drilling
without encoder: Dwell time at final drilling depth
Exact stop
Precontrol
Acceleration
Spindle
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Unit
mm
mm
s
rpm
Milling