Tracking Measurements - Siemens SINUMERIK Series Operating Manual

Procedure
The selection of the axis to be measured depends on the configuration.
References
Information on the configuration is provided in the following reference:
System Manual "Ctrl-Energy", SINUMERIK 840D sl / 828D
19.2.4

Tracking measurements

You have the option of graphically displaying the actual and saved measurement curves.
Precondition
Procedure
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
1. Press the "Start measurement" softkey.
The "Setting Measurement: Select Device" window opens.
2. Select the desired device in the list, possibly activate the "Measure part
program" checkbox, enter the number of repetitions, select the required
channel, and press the "OK" softkey.
The trace is started.
3. Press the "Stop measurement" softkey.
The measurement is terminated.
4. Press the "Save measurement" softkey to save the consumption values
of the actual measurement.
You have pressed the "Ctrl-E analyse" softkey and the "Ctrl-E analyse"
window has been opened.
1. Press the "Graphic" softkey.
The actual measurement is displayed as a blue measurement curve in
the "Ctrl-E analyse" window.
2. Press the "Saved measurements" softkey to display the measurements
last saved.
In addition, measurement curves with 3 different colors paths are dis‐
played together with the measurement time.
3. Press the "Saved measurements" softkey again if you only want to see
the actual measurement.
Ctrl-Energy
19.2 Ctrl-E analysis
875