Siemens SINUMERIK Series Operating Manual page 398

Programming technological functions (cycles)
10.1 Drilling
Procedure
Parameters in the "Input complete" mode
G code program parameters
Input (only for G code)
PL Machining plane
RP Retraction plane
SC Safety clearance
Parameter Description
Compensating
● With compensating chuck
chuck mode
● Without compensating chuck
Machining posi‐
● Single position
tion (only for G
Drill hole at programmed position
code)
● Position pattern
Position with MCALL
Z0 (only for G Reference point Z
code)
Z1 End point of the thread (abs) or thread length (inc)
It is inserted into the workpiece until it reaches Z1.
Machining - (with You can select the following technologies for tapping:
compensating
● With encoder
chuck)
Tapping with spindle encoder
● Without encoder
Tapping without spindle encoder - the following fields are displayed:
–
–
Note:
For ShopMill, the selection box is only displayed if tapping without encoder is enabled.
Please observe the information provided by your machine manufacturer.
398
1. The part program or ShopMill program to be processed has been created
and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Thread" and "Tap" softkeys.
The "tapping" input window opens.
● complete
mm
mm
Select the "pitch" parameter (only G code)
Enter parameter "DT" (only ShopMill)
ShopMill program parameters
T Tool name
D Cutting edge number
S / V Spindle speed or constant cutting
rate
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
rpm
m/min
Unit
mm
mm
Milling