Siemens SINUMERIK Series Operating Manual page 46

Introduction
2.4 User interface
Display
D
H
Ø
R
L
Z
X
Feed data
Display
F
Rapid traverse
0.000
Override
Spindle data
Display
S
S1
Speed
Symbol
46
Meaning
Cutting edge of the current tool
The tool is displayed with the associated tool type symbol corresponding to
the actual coordinate system in the selected cutting edge position.
If the tool is swiveled, then this is taken into account in the display of the
cutting edge position.
In DIN-ISO mode the H number is displayed instead of the cutting edge num‐
ber.
H number (tool offset data record for DIN-ISO mode)
If there is a valid D number, this is also displayed.
Diameter of the current tool
Radius of the current tool
Length of the actual tool
Z value of the current tool
X value of the current tool
Meaning
Feed disable
Actual feed value
If several axes traverse, is displayed for:
● "JOG" mode: Axis feed for the traversing axis
● "MDA" and "AUTO" mode: Programmed axis feed
G0 is active
No feed is active
Display as a percentage
Meaning
Spindle selection, identification with spindle number and main spindle
Actual value (when spindle turns, display increases)
Setpoint (always displayed, also during positioning)
Spindle status
Spindle not enabled
Spindle is turning clockwise
Spindle is turning counterclockwise
Spindle is stationary
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Milling