Grooving (Cycle952) - Siemens SINUMERIK Series Operating Manual

Parameter Description
DX Maximum depth infeed - (only for parallel to the contour, as an alternative to D).
Do not round contour at end of cut.
Always round contour at end of cut.
Uniform cut segmentation
Round cut segmentation at the edge
only for align cut segmentation at the edge:
Constant cutting depth
Alternating cutting depth
Allowance Allowance for pre-finishing - (only for ∇∇∇)
● Yes
U1 contour allowance
● No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
● Positive value: Compensation allowance is retained
● Negative value: Compensation allowance is removed in addition to finishing
allowance
Set machining Set machining area limits
area limits
● Yes
● No
With limited machining area only, yes:
XA 1. Limit XA ∅
XB 2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)
ZA 1. Limit ZA
ZB 2. Limit ZB (abs) or 2nd limit referred to ZA (inc)
Relief cuts Machine relief cuts
● Yes
● No
FR Insertion feedrate, relief cuts
* Unit of feedrate as programmed before the cycle call
10.5.9

Grooving (CYCLE952)

Function
The "Grooving" function is used to machine grooves of any shape.
Before you program the groove, you must define the groove contour.
If a groove is wider than the active tool, it is machined in several cuts. The tool is moved by a
maximum of 80% of the tool width for each groove.
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Programming technological functions (cycles)
10.5 Contour turning - Milling/turning machine
Unit
mm
s
mm
mm
*
603