Example, Standard Machining - Siemens SINUMERIK Series Operating Manual

Creating a ShopMill program

9.18 Example, standard machining

9.18 Example, standard machining
General
The following example is described in detail as ShopMill program. A G code program is
generated in the same way; however, some differences must be observed.
If you copy the G code program listed below, read it into the control and open it in the editor,
then you can track the individual program steps.
Tools
The following tools are saved in the tool manager:
Tool name
Face miller
End mill
End mill
End mill
Centering tool
(NC spotdrill)
Twist drill
The correction (compensation) values for length and radius as well as the tip angle for drills
and number of teeth for milling tools should be entered into the tool list. If you are working with
ShopMill, in addition, enter the spindle direction of rotation and coolant.
Adapt the cutting data to the tools used and the specific application conditions.
Blank
Dimensions: 185 x 185 x 50
Material: Aluminum
354
Machine manufacturer
Under all circumstances, observe the machine manufacturer's instructions.
Tool diameter
D80 mm
D20 mm
D10 mm
D8 mm
D10 mm
D10 mm
Cutting materials
HM
HM
HM
HM
HM
HSS
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Number of teeth
Z = 8
Z = 3
Z = 3
Z = 3
-
-
Milling