Setting-Up Events - Siemens SINUMERIK Series Operating Manual

20.4

Setting-up events

In the "Send SMS for the following events" area, select the events using the check box, which
when they occur, an SMS is sent to the user.
● Programmed messages from the part program (MSG)
In the part program, program an MSG command via which you receive an SMS.
Example: MSG ("SMS: An SMS from a part program")
● Select the following events using the <SELECT> key
– The workpiece counter reaches the following value
– The following program progress is reached (percent)
– Actual NC program reaches runtime (minutes)
– Tool usage time reaches the following value (minutes)
● Messages/alarms from the Tool Manager
An SMS is sent if messages or alarms are output to the Tool Manager.
● Measuring cycle messages for tools
An SMS is sent if measuring cycle messages are output that involve tools.
● Measuring cycle messages for workpieces
An SMS is sent if measuring cycle messages are output that involve workpieces.
● Sinumerik messages/alarms (error when executing)
An SMS is sent if NCK alarms or messages are output that cause the machine to come to
a standstill.
● Machine faults
An SMS is sent if PLC alarms or messages are output that cause the machine to come to
a standstill (i.e. PLC alarms with an Emergency Stop response).
● Maintenance intervals
An SMS is sent if the service planner registers pending maintenance work.
● Additional alarm numbers:
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
Requirement
● The "User profiles" window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle messages
for workpieces", "Sinumerik messages/alarms (errors when executing)", "Machine faults"
or "Maintenance intervals".
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
An SMS is sent if the workpiece counter reaches the set value.
An SMS is sent if, when executing a part program, the set progress is reached.
An SMS is sent after the set runtime has been reached when executing an NC program.
An SMS is sent if the usage time of the tool reaches the set time when executing a part
program (derived from $AC_CUTTING_TIME).
Easy Message (828D only)
20.4 Setting-up events
885