Teach In Rapid Traverse G0; Teach In Straight G1; Teaching In Circle Intermediate And Circle End Point Cip - Siemens SINUMERIK Series Operating Manual

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Teaching in a program

17.4 Teach-in via window

Teach in rapid traverse G0

You traverse the axes and teach-in a rapid traverse block with the approached positions.

Selection of axes and parameters for teach-in

You can select the axes to be included in the teach-in block in the "Settings" window.

You also specify here whether motion and transition parameters are offered for teach-in.

You traverse the axes and teach-in a machining block (G1) with the approached positions.

Selection of axes and parameters for teach-in

You can select the axes to be included in the teach-in block in the "Settings" window.

You also specify here whether motion and transition parameters are offered for teach-in.

Enter the intermediate and end positions for the circle interpolation CIP. You teach-in each of

these separately in a separate block. The order in which you program these two points is not

Make sure that the cursor position does not change during teach-in of the two positions.

You teach-in the intermediate position in the "Circle intermediate position CIP" window.

You teach-in the end position in the "Circle end position CIP" window.

Press the "Cancel" softkey to cancel your input.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0