Siemens SINUMERIK Series Operating Manual page 439

Parameter Description
The positions refer to the reference point:
X0 Reference point X – (for single position only)
Y0 Reference point Y – (for single position only)
Z0 Reference point Z – (single position only and G Code position pattern)
W Width of spigot
L Length of spigot
R Corner radius
α0 Angle of rotation
Z1 Spigot depth (abs) or depth relative to Z0 (inc) - (only for ∇ and ∇∇∇)
DZ Maximum depth infeed - (only for ∇ and ∇∇∇)
UXY Plane finishing allowance for the length (L) and width (W) of the rectangular spigot.
Smaller rectangular spigot dimensions are obtained by calling the cycle again and pro‐
gramming it with a lower finishing allowance. - (only for ∇ and ∇∇∇)
UZ Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇)
W1 Width of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
L1 Length of blank spigot (important for determining approach position) - (only for ∇ and
∇∇∇)
FS Chamfer width for chamfering - (for chamfering only)
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only)
* Unit of feedrate as programmed before the cycle call
Parameters in the "Input simple" mode
G code program parameters
Input
Milling direction
RP Retraction plane
F Feedrate
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
● simple
mm
*
Programming technological functions (cycles)
ShopMill program parameters
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
10.2 Milling
Unit
mm
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
mm
mm
mm
mm
mm/min
mm/rev
rpm
m/min
439