Siemens SINUMERIK Series Operating Manual page 763

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

The SELECT instruction selects a program for execution in a specific NC channel. The selected

program must be loaded into the working memory of the NC. The DISK parameter enables

the selection of external execution (CF card, USB data carrier, network drive).

Absolute or relative path specification of the program to be selected.

– //NC/WCS.DIR/SHAFT.WPD/SHAFT1.MPF

– SHAFT2.MPF

● <Channel number>

Number of the NC channel in which the program is to be selected.

Optional parameter for programs that are not in the NC memory and are to be executed

"externally".

SELECT //remote/myshare/shaft3.mpf CH=1 DISK

Comments are identified in the job list by ";" at the start of the line or by round brackets.

You can select a template from Siemens or the machine manufacturer when creating a new

Executing a workpiece

If the "Select" softkey is selected for a workpiece, the syntax of the associated job list is checked

and then executed. The cursor can also be placed on the job list for selection.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0

14.4 Creating a directory / program / job list / program list

Select the "Program manager" operating area.

Press the "NC" softkey, and in directory "Workpieces" place the cursor

on the program for which you wish to create a job list.

Press the "New" and "Any" softkeys.

The "Any New Program" window opens.

Select entry "Job list JOB" from the "Type" selection field and enter a

name and press the "OK" softkey.

Managing programs