Status Display - Siemens SINUMERIK Series Operating Manual

6 Display of active G functions, all G functions, auxiliary functions and input window for different functions (for example,
skip blocks, program control).
7 Horizontal softkey bar
8 Dialog line to provide additional user notes.
9 Operating window with program block display
10 Position display of the axes in the actual values window
11 Channel state and program control
12 Program name
Figure 2-3 User interface
2.4.2

Status display

The status display includes the most important information about the current machine status
and the status of the NCK. It also shows alarms as well as NC and PLC messages.
Depending on your operating area, the status display is made up of several lines:
● Large status display
The status display is made up of three lines in the "Machine" operating area.
● Small status display
In the "Parameter", "Program", "Program Manager", "Diagnosis" and "Start-up" operating
areas, the status display consists of the first line from the large display.
Status display of "Machine" operating area
First line
Ctrl-Energy - Power rating display
Display
The power rating display must be switched on in the status line.
Note
Information about configuration is available in the following reference:
System Manual "Ctrl-Energy", SINUMERIK 840D sl / 828D
Active operating area
Display
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Description
The machine is not productive.
The machine is productive and energy is being consumed.
The machine is feeding energy back into the grid.
Description
"Machine" operating area
With touch operation, you can change the operating area here.
"Parameter" operating area
Introduction
2.4 User interface
41