Activating The "Teach In" Function - Siemens SINUMERIK 840D sl Commissioning Manual

Activating the machining time display
Timers are provided as system variables in the Program runtime function. Whereas the
NCK-specific timers are always activated (for time measurements since the last controller
ramp-up), the channel-specific timers must be started via the following machine data.
MD27860 $MC_PROCESS_TIMERMODE
Bit 0 = 1
Bit 1 = 1
Bit 4 = 1
Bit 5 = 1
Deactivating simulation
1. Copy the "slsimconfigsettings.xml" file to the
2. Store the file in the following directory: /User/sinumerik/hmi/cfg or /Oem/sinumerik/hmi/cfg
3. Restart HMI sl.
10.9

Activating the "Teach In" function

The "Teach In" function is enabled via general machine data and activated in the "AUTO"
and "MDA" modes with the "Teach progr." softkey.
Settings
MD51034 $MNS_TEACH_MODE
Bit 0 = 1
Bit 1 = 1
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
The measurement of the total runtime for all part programs is active
($AC_OPERATING_TIME)
The measurement of the current program runtime is active
($AC_CYCLE_TIME)
Measurement also during active dry run feedrate
Measurement also during program test
Siemens/sinumerik/hmi/appl/systemconfig/simulation directory.
If the "slsimconfigsettings.xml" file is already available in the directory, only add the
entries from the "slsimconfigsettings.xml" Siemens file.
The softkeys for the simulation selection are no longer available.
Standard teach in. The "Teach progr." softkey is displayed. The approached
position is taken into the program with the "Accept" softkey.
The acceptance of the teach-in block can be blocked by the PLC.
DB19.DBX13.0 = 0 Block is accepted
DB19.DBX13.0 = 1 Block is not accepted
Customizing the "Machine" operating area
10.9 Activating the "Teach In" function
71