Editing A Program Block - Siemens SINUMERIK Series Operating Manual

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Edit PLC user program (828D only)

23.5 View of the program blocks

All the operations supported by the PLC type are available for the editing. Subprograms and

interrupt programs can be added and deleted.

Saving changes

If you make changes in the program, you must save the project before you change from the

PLC area to another operating area. You can transfer the project to the PLC using the "Load

to CPU" softkey. If this is not done, all of the changes will be lost and must be re-entered.

Please note the corresponding program information:

Editing functions

● Edit block

– Create connecting lines, contacts, coils, and boxes

– Change operands

– Delete operations

For information, please refer to the Basic Functions Function Manual, Chapter P4: PLC for

SINUMERIK 828D

Editing a program block

You can edit program blocks.

Before you can edit program blocks, the program status must have stopped.

If the status is active, you will receive a message that the program status must have stopped.

Create and then edit a new network

Subsequently edit networks

Delete networks

To stop the program status automatically, press the "OK" softkey.

To stop the program status, press the "Program stat." softkey again.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0